CHW Wide-Web Splicer
Overview:
The CHW (cantilevered hot-wire lap splicer) is Martin’s creative and effective answer to automatic splicing of non-wovens, tissues and extensible films. An integrated roll spindle/splice unit, hot-wire cut-off system and patented tension control system combine to offer the manufacturer using non-woven, tissues or extensible films incomparable value in automatic splicing and tension control.
The integrated roll-spindle/ splice unit allows in-aisle roll loading and splice preparation. The splice unit has been designed a s two separate halves, with one half of the splice unit attached to each roll-spindle structure. The roll-spindle/splice unit extends into the aisle allowing unobstructed roll leading splice preparation. A pneumatic lift carries the roll back into its running position.
A hot-wire cut-off system replaces the traditional knife cut-off system found on most splicers. This hot-wire system is a sale, clean and reliable alternative to knife systems. In addition, the CHW hot-wire system automatically trims the leading edge of a newly prepped web, ensuring a consistent tail-length.
The CHW is designed to run at tensions as low as .5 lbs total tension. A patented tension control system incorporated with either spindle drives or Martin’s unique braking system ensures tension accuracy within .25 lb total variation during running and splicing cycles.
Specifications: **
Maximum Splicing Speed | to 2500 FPM | to 762 MPM |
Maximum Web Width | to 75 IN | to 1905 MM |
Maximum Roll Diameter | to 60 IN | to 1524 MM |
** Specifications for the Martin CHW Wide-Web Splicer are meant as a general guideline. The Martin CHW Wide-Web Splicer can be application-engineered to fit each process. Contact Martin Automatic for your specific needs.
Features:
- Fixed, cantilevered spindle design
- Lift-and-load feature keeps rolls close to the ground
- Pivoting split splice unit
- Easy access, in-aisle splice preparation
- Hot wire cut-off for either lap or optional heat-seal butt splice
- Tape lap splice
- Out-board support for securing rolls in the running position
Optional Features:
- Heat seal lap splice
- Martin’s patented Heat Seal Butt Splice
- CE Certification
- 3/4” Expansion spindles for easier roll loading
- In-Register Splicing Package
Requirements:
Electrical | Per Application | |
Pneumatic | to 80 PSI | to 5 ATM |
Downloads:
As with all Martin products, the Martin CHW Wide-Web Splicer can be application-engineered to fit each process. Contact Martin Automatic for your specific needs.